Type

Database

Creator

Date

Thumbnail

Search results

7 records were found.

ATF2 is a low energy (1.3GeV) prototype of the final focus system for ILC and CLIC linear collider projects. A major goal of ATF2 is to demonstrate the ability to stabilise the beam position at the interaction point, where the beam can be focused down to about 35 nm. For this purpose, a set of new Beam Position Monitors (BPM) has been designed, with an expected resolution of about 2 nm. These BPMs must be very well aligned with respect to the beam, at the few micron level, to fully exploit their fine resolution. In this paper, the mechanical positioning system which has been developed to enable such a precise alignment is presented. It is based on a set of eight piezo actuators with nanometer range displacement resolution, mounted in a new specially made vacuum chamber. Due to the expected resolution of the piezo actuators, this system...
We are developing a diamond detector for beam halo and Compton spectrum diagnostics after the interaction point (IP) of ATF2, a low energy (1.3 GeV) prototype of the final focus system for ILC and CLIC linear collider projects. Tests of a 500 μm thick sCVD diamond detector with a dimension of 4.5 mm×4.5 mm have been carried out with radioactive sources and with electron beam from PHIL low energy (<10 MeV) photo-injector at LAL. The tests at PHIL were done with different beam intensities in air, just after the exit window at the end of the beam line, to test the response of the diamond detector and the readout electronics. We have successfully detected signals from single electrons, using a 40 dB amplifier, and from an electron beam of 108 electrons, using a 24 dB attenuator. A diamond sensor with 4 strips has been designed and fabricat...
The ATF2 final focus prototype features an ultra-low emittance beam focused down to a less than 40 nm vertical beam size at the focal point. The development of dedicated instrumentation enabling the fluctuations of the beam to be measured with a few nm accuracy, as input to a feedback control loop, is reported. A set of special low-noise cavity-BPMs has been prepared with a decay constant short compared to the 300 ns time separation of ILC-like bunch trains which will be used. Installation is planned in a new vacuum vessel, custom made to provide adjustment capabilities in three dimensions for in situ relative alignment and calibration purposes. A fast kicker and feedback algorithm are in preparation for deployment later in the year.
This report describes the present status of the detector design for SuperB. It is one of four separate progress reports that, taken collectively, describe progress made on the SuperB Project since the publication of the SuperB Conceptual Design Report in 2007 and the Proceedings of SuperB Workshop VI in Valencia in 2008. The other three reports relate to Physics, Accelerator and Computing.
In this Technical Design Report (TDR) we describe the SuperB detector that was to be installed on the SuperB e+e- high luminosity collider. The SuperB asymmetric collider, which was to be constructed on the Tor Vergata campus near the INFN Frascati National Laboratory, was designed to operate both at the Upsilon(4S) center-of-mass energy with a luminosity of 10^{36} cm^{-2}s^{-1} and at the tau/charm production threshold with a luminosity of 10^{35} cm^{-2}s^{-1}. This high luminosity, producing a data sample about a factor 100 larger than present B Factories, would allow investigation of new physics effects in rare decays, CP Violation and Lepton Flavour Violation. This document details the detector design presented in the Conceptual Design Report (CDR) in 2007. The R&D and engineering studies performed to arrive at the full detector ...
Want to know more?If you want to know more about this cutting edge product, or schedule a demonstration on your own organisation, please feel free to contact us or read the available documentation at http://www.keep.pt/produtos/retrievo/?lang=en